Custom Made - Recyclable - Hygienic
Custom Made - Recyclable - Hygienic
by Brian Mangum | Sep 23, 2021
In this post, we are going to discuss the bacterial adherence to the different type of casting materials. The following excerpt was taken from the American Association for Hand Surgery.
Bacterial Adherence to Casting Materials
Joseph E Massaglia, D.O.1, Cory Lebowitz, D.O.1, Keith Fitzgerald, B.S.2, Noreen Hickok, Ph.D. 2, Pedro K Beredjiklian, MD3 and Michael Rivlin, M.D.4, (1)Rowan School of Osteopathic Medicine, Stratford, NJ, (2)Thomas Jefferson University, Philadelphia, PA, (3)Rothman Orthopaedic Institute, Philadelphia, PA, (4)Rothman Institute, Philadelphia, PA
INTRODUCTION: This study aims to evaluate the bacterial adherence and ease of decontamination of commonly used casting materials including Plaster, Fiberglass, Plastic (3D printed), and Waterproof liner. We hypothesize that there will be a significant decrease in bacterial counts remaining on the material after washed with soap solutions compared to a saline control, especially in non-porous waterproof material.
MATERIALS & METHODS: The minimal inhibitory concentration of two phosphate-free soaps that achieved total bacterial kill off was determined. The anti-bacterial ingredient in detergent #1 and #2 was triclosan 0.10% and lactic acid, respectively. After inoculation with Staphylococcus aureus, scanning electron micrographs were performed. Using one of two soaps or saline (PBS), the materials were washed. Each material was run in 18 replicates: 6 with PBS, 6 with detergent #1, and 6 with detergent #2. Materials were then washed with PBS and sonicated to remove the remaining bacteria on the materials’ surface and cultured. Colony forming unit (CFU) counts were recorded. The washing protocol was repeated for a total of 3 trials.
RESULTS: Washing with either soap significantly decreased the remaining CFU for all materials studied. The mean remaining CFU of Plaster, Plastic, and Fiberglass after washings with either soap was compared to one another. Plaster material partially decompensated in the washing process. The mean remaining CFU of Plastic showed to be significantly less than that of Plaster and Fiberglass when washed with detergent #1. No statistical significance was observed between remaining CFU of the materials washed with detergent #2.
CONCLUSION: The current study demonstrates that soap solutions compared to a saline control are significantly more effective at decreasing the bacterial load on cast material surfaces that are waterproof (Plastic and Fiberglass). 3D printed plastic cast material when washed with detergent #1 is superior in decontamination of bacteria to other materials observed. While no objective data exists to guide the choice of casting material, the current study suggests that this decision in addition to washing casts may play a role in decreasing wound infection in a clinical setting.
-AAHS-https://meeting.handsurgery.org/abstracts/2020/HSEP233.cgi
Per the aforementioned study, 3D printed casts had a decontamination that far exceeded the other materials that are used in casting. This is exactly what we offer here at ActivArmor. A custom 3D printed cast made from ABS plastic that is washable, sanitizable and sterilizable. This is a game changer for those professionals providing medical care and those in the food handling industry. Wearing an ActivArmor device is a huge benefit for the wearer since you can stay safer from bacteria. Click the link below for pictures from a study done in 2019. Visit us at www.ActivArmor.ca or email us at info@ActivArmor.ca
We use cookies to analyze website traffic and optimize your website experience. By accepting our use of cookies, your data will be aggregated with all other user data.